6/21/2023 0 Comments Arduino 1.8.5 drivers![]() ![]() ![]() the loop routine runs over and over again forever:ĭigitalWrite(0, HIGH) // turn the LED on (HIGH is the voltage level)ĭigitalWrite(0, LOW) // turn the LED off by making the voltage LOW initialize the digital pin as an output. Here is the code it will load: // the setup routine runs once when you press reset: If you're just getting started try the above procedure with the example you can find by going to File→Examples→Digispark→Start ![]()
0 Comments
Leave a Reply. |